What You Need to Know Before You Start
A quick connect union tee lets you split your aquarium filter line without cutting or gluing. The Tube OD Union Tee Type Plastic Push to Quick Connect Tube Fitting (10 Pack) from Castle Dawn Aquatics uses a push-fit lock that disconnects quickly and requires no tools. Before you begin, confirm your tube's outside diameter matches one of the available sizes: 6 mm, 8 mm, 10 mm, or 12 mm. If you are unsure which size fits your plumbing, the manufacturer recommends sending a message for help.
Product Specifications at a Glance
- Tube OD Union Tee Type Plastic Push to Quick Connect Tube Fitting (10 Pack): The T Tee piece union connector uses a Push-fit lock which allows for quick disconnection without the need for tools. You can add or remove the tee from your filter line in seconds without wrenches or sealant.

Tube OD Union Tee Type Plastic Push to Quick Connect Tube Fitting (10 Pack) - Tube OD Union Tee Type Plastic Push to Quick Connect Tube Fitting (10 Pack): Pressure: 0-0.9Mpa. Proof pressure: 1.32Mpa. Working Temperature: 0-60°C. These limits cover typical aquarium filter pumps and room-temperature water, but confirm your pump's pressure rating stays within 0.9 MPa.
- Tube OD Union Tee Type Plastic Push to Quick Connect Tube Fitting (10 Pack): Applicable pipe: PU/PA/PE/PVC. The tee works with common aquarium tubing materials, so you likely already have compatible hose.
Step-by-Step Installation
Follow these steps to add a union tee to your aquarium filter line. Work over a bucket or towel to catch any drips.
- 1. Turn off the filter and drain the line: Switch off your aquarium filter and disconnect the hose from the filter outlet or inlet. Let the water drain into a bucket.
- 2. Cut the hose at the desired branch point: Use a sharp utility knife or hose cutter to make a clean, square cut. A straight edge ensures a good seal with the push-fit fitting.
- 3. Push the hose ends into the tee: Insert each cut hose end firmly into one of the tee's three sockets. The push-fit lock will grip the tubing — no twisting or tools required.
- 4. Attach the branch line: Connect a third piece of hose to the remaining tee outlet. This line can run to a second filter, a reactor, or a spray bar.
- 5. Test for leaks: Restart the filter and check all three connections for drips. If you see a leak, push the hose in a bit further or trim a fresh end.
Important Notes on Compatibility
The Tube OD Union Tee is made from FDA compliant materials, making it safe for aquarium use. The working temperature range of 0-60°C covers all typical aquarium environments. The pressure rating of 0-0.9 MPa (about 130 psi) suits most canister and hang-on-back filter pumps, but always verify your pump's maximum pressure. If your tubing is not PU, PA, PE, or PVC, the fitting may not seal properly.

