Worn out or just dirty? Start by telling them apart
A sponge that looks dark and clogged is not automatically a sponge that needs replacing. In an air-driven corner bio filter, the sponge is the surface where beneficial bacteria live, so the default move is to clean it, not swap it. Cleaning preserves that colony; replacing throws it away.
The distinction matters because the two problems look similar from outside the tank: flow slows, the sponge darkens, and debris collects. Before you order new media, decide whether you are dealing with buildup that cleaning can lift, or material that has genuinely broken down.
Signs the sponge itself has failed
These are material-level problems. Cleaning will not reverse them, and they are the point at which replacement becomes the sensible answer.
- The sponge crumbles or sheds fibers: A sponge that leaves bits in the water or falls apart when squeezed has lost structural integrity. No amount of rinsing restores it.
- It stays compressed after squeezing: A sponge that no longer springs back has lost the open pore structure that lets water pass through it.
- Torn walls or a split barrel: Cracks and tears let water bypass the media instead of passing through it, which defeats the filter's job.
- Persistent slow flow after a proper clean: If flow stays weak after cleaning, the pores may be permanently clogged or the material degraded. Check the air supply and tubing too, since those are separate causes of weak flow.
What actually wears a sponge out
Sponges age from the inside out. Repeated squeezing, chlorine in tap water during rinsing, and the simple accumulation of fine debris in the pores all shorten useful life. The material in this listing is 100% cotton, which is a natural fiber; natural fibers generally break down over time in a wet, biologically active environment. That makes eventual replacement normal rather than a sign you did something wrong.
The practical takeaway: clean gently, rinse in tank water rather than tap water where possible, and accept that a cotton-based sponge has a finite service life.
What the XY-2890 replacement pack gives you
- Aquarium Corner Bio Sponge Filter Replacement Sponges XY-2890 Pack of 10: Pack of 10 layered replacement sponges for corner air-driven bio sponge filters. Having spares on hand means you can replace a failed sponge without leaving the filter empty while you shop.

Aquarium Corner Bio Sponge Filter Replacement Sponges XY-2890 Pack of 10 - Aquarium Corner Bio Sponge Filter Replacement Sponges XY-2890 Pack of 10: Suitable for aquariums up to 50 litres. Check your tank volume first; this pack is sized for small setups, not large tanks.
- Aquarium Corner Bio Sponge Filter Replacement Sponges XY-2890 Pack of 10: Size XY-2890: 5 x 5.5 cm (H x L). Measure your existing sponge and filter body against these dimensions before ordering.
- Aquarium Corner Bio Sponge Filter Replacement Sponges XY-2890 Pack of 10: The replacement sponges are universal and will fit any brand of aquarium bio sponge filter of similar size and design. You are not locked into one filter brand, but similar size and design is the condition that makes the fit work.
- Aquarium Corner Bio Sponge Filter Replacement Sponges XY-2890 Pack of 10: Filter not included. This is media only; if your problem is the air pump or the filter body, this pack will not solve it.
A sensible replacement routine
Replace one sponge at a time where your filter allows it, so you are not stripping all the biological surface at once. The steps below assume a corner air-driven bio sponge filter with a removable sponge.
- Confirm the diagnosis: Rule out a clogged air line, a failing pump, or simple debris buildup before you conclude the sponge is worn out.
- Measure the old sponge and the filter body: Compare against the XY-2890 size of 5 x 5.5 cm (H x L) and the up-to-50-litre suitability.
- Have the replacement ready before removing the old one: A pack of 10 means you can keep spares on the shelf rather than improvising.
- Swap the sponge and keep the old one out of the tank: Discard a crumbling sponge; do not leave fragments where fish can pick at them.
- Watch flow and clarity over the next few days: If flow does not improve, the sponge was not the cause and you need to look at the air supply or filter body.
How many spares do you actually need?
A pack of 10 is generous for a single small filter. The value is in having replacements ready when a sponge fails, and in being able to rotate rather than panic-buy. If you run several small tanks or a small rack of breeding tanks, the pack covers multiple filters at once.
If you have one tank and one filter, the honest tradeoff is that most of the pack will sit in storage. That is fine if you accept it as a convenience purchase, but it is not a reason to replace sponges more often than they actually wear out.
When the sponge is not the problem
Weak flow, cloudy water, or a filter that seems to do nothing can come from the air pump, blocked tubing, a missing impeller, or an oversized tank for the filter's rating. The XY-2890 pack is media only; it will not fix an air supply problem or a filter body that has cracked. Diagnose the whole system before you spend on replacements.
The supplied information does not include a recommended replacement interval, so treat the signs above rather than a calendar. If your sponge is intact, springy, and flowing well after cleaning, it does not need replacing yet.

